Stamping die is a kind of important equipment used for metal stamping manufacturing, and its installation and commissioning methods are crucial to ensure the proper working of the die and the quality of the product. This article will introduce the installation and commissioning methods of stamping die, including unguided stamping die and stamping die with guiding device.

I. Installation

1. Preparation: Before installing the stamping die, it is necessary to prepare the required tools and equipments, such as spanners, screwdrivers, pliers and so on. At the same time, it is necessary to check the appearance and size of the mould to ensure that it meets the design requirements.

2. Install the base: Install the base of the stamping die on the press and make sure the position and height of the base meet the design requirements.

3. Installation of moulds: Install the upper and lower moulds of the stamping moulds on the base and make sure that the position and height of the moulds are in accordance with the design requirements.

4. Installation of guiding device: for stamping moulds with guiding device, it is necessary to install the guiding device and make sure that the position and height of the guiding device are in accordance with the design requirements.

5. Installation of press connecting rod: for unguided stamping dies, it is necessary to adjust the length of the press connecting rod to ensure that the position and height of the die meet the design requirements.

Second, debugging

1. Test punch: after the installation is completed, it is necessary to carry out test punch to check the working condition of the mould. In the process of trial punching, it needs to be adjusted and trimmed according to the cause of faults so as to make the mould work normally.

2. Pressure adjustment: according to the result of trial punching, adjust the pressure of the press to make sure the mould can work normally.

3. Adjust the clearance of the convex and concave moulds: for the stamping moulds with guiding device, it is necessary to adjust the clearance of the convex and concave moulds to ensure that the moulds work well.

4. Adjust the slide position: for the stamping mould with guiding device, it is necessary to adjust the slide position to ensure the mould working condition is good.

5. check the working condition of the mould: after the debugging is completed, the working condition of the mould needs to be checked to ensure that it meets the design requirements.

In a word, the installation and debugging of the stamping mould need to be careful and patient to ensure the normal working of the mould and the quality of the products. In the process of installation and commissioning, you need to pay attention to safety and comply with the relevant operating procedures.